Air Cleaners
AVO Dampers
Bafled Sumps
Bearings
Bellhousings
Block Bolts
Brackets/Mountings
Cam Followers
Camshafts
Carbs and Injection
Cobra Seats
Con-Rods
Cooling accessories
Crankshafts
Cylinder Block
Cylinder Heads
Electrical
Engine Pulley's
Exhaust Manifolds
Flywheel/Clutch
Gaskets/Seals
Gearboxes
Inlet Manifolds
Long Engines
Miscellaneous
Oil/Lubrication
Pistons/Rings
Short Motors
Stroker Crank Kits
Suspension
Turnkey Engines
Valves/Timing
Water Pumps
Home > Electrical/Ignition
You're viewing 1 - 25 of 48 products in this category
MSD Electronic Billet Alloy Race Dist.
Magnetic Trigger type distributor requires
MSD Ignition unit & Ignition coil.

Features adjustable mechanical advance for fine tuning the advance curve (no vac advance)
For pre and post 1976 Rover V8 engines.
(advance springs and bushings supplied)

Supplied with Early drive gear
Can also b......
more >>
Recon. Alternators
Kit Car Alternators recon units will require the RV8 P6 mounting bracket - these available separately if required.
12 months guarantee
45 amp unit
supplied with pulley
more >>
Rotor Arm
To Suit 1976 > Engines
more >>
Heavy Duty Starter Motor
Heavy Duty Starter Motor as fitted to 4.6 Litre engines.

Will also fit
Rover SD1
Morgan
TVR
Range Rover 3.5,3.9 & 4.2
Land Rover Discovery 3.5,3.9
Range Rover 4.0 and 4.6

These units have the starter solenoid mounted to the side so may not be suitaqble for MGB V8 for example. However s......
more >>
P5B/P6 service kit
Points set
Condeser
Rotor Arm
more >>
Coil Bracket (Chrome)
To Suit Morroso/Mallory/MSD or other V8 coils
more >>
Distributor Drive Gear PRE SD1 Engine
Foe Pre SD1 and some early Range Rover engines.
more >>
Distributor to Cam Drive gear (inc coupling)
As originaly used on the SD1 Distributors such as
Lucas DE8,DLM8 Electronic as well as for conversion of Single Point or Mallory Dual Point Distributors
more >>
MSD Blaster 2 Coil
These ignition coils offer 45 Kv performance and is suitable for high perfromance and race applications.

Only for use with MSD Distributor and MSD Ignition Controller such as MSD 6 or 6AL

High Performance Ign. Leads also required

Ballast Resistor Not required
more >>
MSD 6AL Ignition Module with rev-limiter
Probably one of the best ignition controllers available at any price. Will ensure complete combustion under the harshest conditions.

These units come ready to install on either points or magnetic trigger and require no ballast resistor.

The units feature an adjustable Soft Touch rev limiter w......
more >>
Morroso Lead Set Mallory/MSD
These spiral core race wires provide a useful upgrade to the Mallory wires.
Use with Mallory Ignitions
or MSD Pro-Billet/6AL control box
more >>
Mallory Electronic Ballast Resistor
For use with Mallory Unilte/Electronic Coils and Distributors
Ohm rating 0.75 - 1.5
more >>
***MSD Ignition Kit***
MSD Pro Billet CNC distributor to suit SD1 or P6 Engines.
(Post 1976 Engines will require drive gear &
coupling
MSD 6AL Ignition controler with variable rev-limiter (New Digital Version)
MSD Blaster Coil 45000 Volt
Morroso Stainless Steel Spiral wound lead set
Set of advance curve springs to ......
more >>
MSD Universal Boost Timing for STD Ignitions
The Universal Boost Timing Master allows you to adjust the ignition timing in relation to the boost pressure plus it has a built-in inductive ignition. You can adjust the dash mounted control knob to retard the timing 1° - 3° per pound of boost, up to 15 °. The increased spark output of the BTM h......
more >>
Lucas Ignition Coil
Suitable for OE Lucas Electronic Distributor Applications.
more >>
Distributor Cap ( Black LUCAS OE)
Distributor Cap to suit all Lucas Distributors.
more >>
Rover V8 Ignition Coil ( Carb Engines Only)
Aftermarket Ignition Coil (Intermotor) to suit Engines fitted with SU or Stromberg/Zenith Carbs. Compatable with Lucas Distributors.

Supplied with Coil Bracket
more >>
Distributor Cap (Blue)
Distributor Cap to suit all Rover V8 Engines 1970 > 1996 3.5,3.9,4.2 etc
more >>
Champion Copper Core Spark Plugs 4.0/4.6 Engines
Champion OE Copper Core Spark Plugs for
4.0 & 4.6 Litre Rover V8 Engines.

Discovery 2 4.0 Litre
Morgan + 8 4.6 Litre
Range Rover V8 4.0/4.6 Litre

Also used on 3.5,3.9 and 4.2 Capacity engines with electronic distributors.

*** Price is per Set (8)***
more >>
Ignition Lead Set (BLUE) 7mm Silicone
Silicone Lead set in Blue 7mm diameter Leads (numbered) complete with King/Coil Lead.

Budget Priced Set but good quality !!

Suitable for most Rover V8 Engines 1970 - 1998
more >>
Lucas BLACK Ignition Lead Set P38 4.0 / 4.6 OE Engines
Full Set of Igntion Leads for 4.0/4.6 P38 Engines
1995 - 1998 (GEMS Engines)

If unsure as to whether your egine has GEMS or MEMS please enquire.
more >>
Oil Pressure Switch
Oil Pressure Switch - fitted to oil pump housing.

All Rover V8 Engines 1987 - 1999
more >>
Oil Pressure Switch
Oil Pressure Switch

To fit
Range Rover P38 MEMS 1999 - 2002
Discovery 2 199 - 2003
more >>
Range Rover Engines 4.0 & 4.6 1995 - 1998/9 Knock Sensor
Knock Sensor for Range Rover P38a Engines

4.0 Litre or 4.6 Litre.

Suit Engines from Model Year 1995 - 1998/1999
GEMS Engine Management System Only

(2 required per engine0
more >>
Spark Plugs ( Champion ) Efi Engines
Rover V8 Engines 1976 > 3.5,3.9,4.2 Carb and Efi

Copper Core Type for max performance
more >>
© Abbey Sportcars Ltd.   |   Company No. 03916786   |   VAT No. 858100630   |