Air Cleaners
AVO Dampers
Bafled Sumps
Bearings
Bellhousings
Block Bolts
Brackets/Mountings
Cam Followers
Camshafts
Carbs and Injection
Cobra Seats
Con-Rods
Cooling accessories
Crankshafts
Cylinder Block
Cylinder Heads
Electrical
Engine Pulley's
Exhaust Manifolds
Flywheel/Clutch
Gaskets/Seals
Gearboxes
Inlet Manifolds
Long Engines
Miscellaneous
Oil/Lubrication
Pistons/Rings
Short Motors
Stroker Crank Kits
Suspension
Turnkey Engines
Valves/Timing
Water Pumps
Home > Camshafts

Pro Cam 229 - Rover V8 Excellent for Off Road

Ground from New Billets and NOT regrinds. Pro cams grind 229 feature a ground in quietening ramp to minimise valve train noise.

Worth 20 BHP over OE camshaft on a 3.5, also suit 3.9,4.2 and later 4.0/4.6 engines that have retained the distributor.

Ideal for most applications where smooth power delivery is required and strong low end torque .

Gives good tickover and also suits automatic trans instalations.

Perfect for 4 x 4 and mild Road/Touring

( Engines marked * ie 3.9, 4.2,4.0,4.6 may require additional machining for installation of cam retaining plate )

Good idle - 850rpm - power from 1500 - 4500rpm
Redline 4500rpm Plus.

This cam should fit straight in without any further engine mods. This however assumes the block decks and cylinder heads have not been extensively machined. If in doubt check clearances whilst assembling.

Use with standard or Rhoads lifters for best performance and check lifter preload setting 0.020 -0.60".
Cam Spec sheet available
Supplied with cam spec sheet and cam lube

Can be used on engines equiped with cam retaining plate if discarded or machine the cam nose to accept cam retaining plate.

Alternatively use Teflon Thrust Bolt Kit to control cam walk

enlarge picture
£219.99
All prices include VAT @ 20%
© Abbey Sportcars Ltd.   |   Company No. 03916786   |   VAT No. 858100630   |